Remedy: 1 Check the power cord for continuity.Description: 126.01 Line frequency outside operating range of device.See “171.xx Cooling fan service check” and “LVPS service check”.
Lexmark unable to scan to computer free#
Are they free of damage and debris? Perform a cooling fan service check and LVPS service check. Step 4 Check the fuser rollers, belts and gears for damage and debris. 100V fuser-8 ohms Is the resistance equal to any of the above values? Perform an LVPS service check.d Check for approximate correct resistance on the fuser cable: c Disconnect the fuser cable connected to PCN5 of the power supply.
Step 2 Are the cables JTHERM1, JEXIT and PCN5 free of damage? Go to step 3. Are they properly connected? Go to step 2. Check the cable PCN5 for proper connection to the power supply.Check the fuser cables JTHERM1 and JEXIT for proper connection to the controller board.
Remedy: 1 Restore the engine settings to their defaults: Diagnostics Menu > Printer Setup > Defaults 2 Restore the EP setup settings to their defaults: Diagnostics Menu > EP Setup > Defaults. 121.37 Fuser heated faster than allowed during line voltage detection. 121.36 Fuser did not heat to allow compression jog. 121.35 Attempting to POR after receiving a 121.34. 121.34 Open fuser backup roll thermistor. 121.30 Fuser failed to reach printing temperature by the time a page reached the fuser. 121.29 Fuser failed to reach pre.heat temperature for motor start during warm up. 
121.28 Failed to reach EP warm up temperature in time. 121.26 Failed to reach temperature during warm up. 121.25 After line voltage detection, control did not roll over to steady state control in time. 121.24 Fuser never reached detection temperature. 121.23 Fuser took too long to heat to line detection temp. 121.22 Fuser did not warm enough to start line voltage detection. 121.20 Fuser undertemp during steady state control. 121.08 Fuser was under temp when page was in fuser.
Description: 121.07 Fuser has been on for more than allowed after a gap blowout, and the temperature is still too cold. Are they free of damage? Replace the controller board. Step 2 Inspect the LSU cables and connectors. Remedy: Step 1 Check the LSU cables JVIDEO1 and JGLV1 for proper connection. 111.67 111.68 Too many fake HSYNCs while aligning printhead. 111.65 111.66 Failed alignment of printhead. 111.64 Attempted to exceed open loop drive limits. 111.62 Closed-loop printhead error, off-resonant PI effort state. 111.61 Printhead drive control out of range due to an external event beyond what the control is designed to handle. 111.60 Closed-loop printhead sweep error, check sweep accuracy state. 111.59 Closed-loop printhead error, forward and reverse capture times differ by too much. 111.58 Closed-loop printhead error, load scan regs state. 111.57 Closed-loop printhead error while waiting for amp Ki to converge. 111.56 Closed-loop printhead error, amp Ki failed to converge. 111.55 Closed-loop printhead error while waiting for amp Kp to converge. 111.54 Closed-loop printhead error, amp Kp failed to converge. 111.53 Open-loop printhead error, enable amp Kp state. 111.51 111.52 Open-loop printhead error, check prelim amp state. 111.40 Wrong printhead installed 111.50 Open-loop printhead error, open-loop sweep state. Description: 111.00 Pel clock check failed.
0 kommentar(er)
